Do It Your-Self
E System Sales, Inc. offers services by phone to help you with your
Panasonic KX-T Installation. A do-it-your-selfer can perform a
Panasonic KX-T installation
KX-T Installation cable
and block kit is purchased. Please
follow these instructions as well as your Installation CD which
your will receive with your Panasonic Telephone Equipment
The Panasonic KX-T Installation cable
and block kit
helps when installing the Panasonic KX-TA824. All Panasonic phone
systems KX-T are plug and play. You will be ready to send and
receive phone calls.
NOTE: 1 pair of wires is required
on all incoming phone lines and 2 wires is required on all phone
66 Block termination
punch down tool is also required for installation.
Punch down the appropriate pair of
wires for each terminal. For example, the 101R, 101T, 101P& 101G
terminals are the terminals for the first phone extension which is
extension 101, and the Line 1R and the Line 1T terminals are for
the first incoming telco line witch is Line 1.
The above diagram is a schematic view
of the telco
66 Block provided in the installation kit.
Click here for a exploded view of a 66-Block. The installer
will notice that there are 2 empty terminals on the bottom of the
66 Block. That is normal.
pairs of wires for CO/Trunk lines
Take your telephone but set.
Take the Alligator clips
the two Alligator clips on to each pair of color coded
(white/Blue blue/white) wires.
Listen for dial
tone, if dial tone exists call your Cell phone and check the
caller IP LCD screen to check the phone number you have dialed
pairs for telephone connections.
Plug the tone generator into
the telco phone jack of the
office location where the
phone is to be installed
In the phone room or
distribution facility run the tone amplifier along each of the
connector punch down interface on the 66 Punch Down Block
until you hear the tone at to its loudest point over two of
the conductors and you have found the pair of wires foe the
phone on the office jack in question.